Clarke ENCORE MAX Manuel de l'opérateur télécharger pdf (Page 18)

1-18 CLARKE

ENCORE MAX

METAL BAR

BRAKE RELEASE LEVER

ELECTRICALLY ACTUATED

MECHANICAL PARKING BRAKE

MACHINE PREPARATION

Fig. 3

WARNING

Disconnect the traction harness before towing the machine.

6) The machine is shipped with a metal bar between the electrically actuated parking brake and the brake

release lever to keep the electrically actuated parking brake disengaged.

7) Push machine down the ramp onto a flat surface.

WARNING

8) Remove the metal bar to engage the electrically actuated mechanical parking brake.

9) Connect rear squeegee hose and install squeegee blade as shown in manual.

10) Remove battery charger from under the seat in battery compartment (if applicable).

11) Install batteries.

-Turn the key to the “O” position

-Lift the hinged seat and cover, then disconnect seat switch and remove seat plate.

-Use a battery lifting device with a 150 LB. (68KG) capacity to place the batteries battery compartment.

-Install Battery wires as shown in manual.

-Plug the polarized connector from the battery on into the 36 Volt plug provided.

-Install scrub brushes as shown in the manual.

-Lower seat and cover assembly.

12) Charge batteries as shown in the manual. Read battery manufacturer literature for battery care and

maintenance.

WARNING

Do not charge batteries on a concrete grounded surface. Hydrogen gas is formed during the charging

operation and is explosive. Only charge batteries in a well ventilated area with the lid open. Avoid

any smoking, open flame, or electrical sparks.

DISCONNECT TRACTION

HARNESS CABLE BEFORE

TOWING THE MACHINE

Fig. 4

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 60 61

Pas de commentaire

Clarke ENCORE MAX Manuel de l'opérateur Page 18