Clarke Boost 32 Manuel de l'opérateur télécharger pdf (Page 22)

ENGLISH

Page -22-

Clarke

Operator's Manual (EN) - BOOST 32

MAINTENANCE

Adjusting Squeegee Blades

When properly installed the front blade should be

approximately .12" (3.0 mm) above the rear blade.

See figure 29.

WARNING: Maintenance and repairs

must be done by authorized

personnel only .

WARNING: Electrical repairs must be

done by authorized

personnel only.

Consult your Clarke Authorized Service Person to do

the service procedures.

Use only genuine Clarke parts.

How to Clean the Solution Line

If the solution line becomes clogged, follow this proce-

dure:

1. Turn the solution valve to the off position. See figure

30, A.

2. Remove and clean the filter screen. See figure 30, B.

3. Install the filter screen. Turn on the solution valve.

Maintenance Procedures That Must Be Done

Every Six Months

Contact a Clarke Authorized Service Center

to perform this six month procedure.

1. Check the carbon brushes in the electric motors.

2. Clean the battery terminals and connectors. Make

sure all of the battery connections are tightened

correctly.

3. Check all of the switches, controls, valves, hoses and

gaskets.

4. Check and remove debris from the transaxle hubs.

5. Replace the rubber isolators (see Ref. #24 in Brush

Head Assembly Parts List section). The rubber

isolators are considered wear items and must be

replaced every 6 months.

6. Replace the rubber mounts (see Ref. #55 in Brush

Head Assembly Parts List section). The rubber

mounts are considered wear items and must be

replaced every 6 months.

Figure 29

Figure 30

.12

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 101 102

Commentaires sur ces manuels

Pas de commentaire

Clarke Boost 32 Manuel de l'opérateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Scrubber Clarke Boost 32