Clarke 00311C Manuel de l'opérateur télécharger pdf (Page 17)

ENGLISH

Clarke

Operator’s Manual (EN) - Focus Rider Form No. 71171A - 17 -

Figure 21

Figure 22

Figure 23

SCREEN 1

SCREEN 2

How To Operate the Machine

How to Read the Battery Meter (see ﬁ gure 21, A)

The battery meter is an indicator on the LCD display. This indicator is

on the LCD display on the front of the machine. It has 10 bars with 10

bars visible indicating a full charge. As you run the machine the bars

will begin to lower. The “Battery Icon” (B) will begin to ﬂ ash to indicate

you are reaching the end of charge.

NOTE: If you continue to run the brushes they will shut down to

protect the batteries from over discharging.

NOTE: Run times will vary depending on machine variables, bat-

tery size, brush pressure and ﬂ oor type, etc.

How to Change Displays Screens on the LCD Module

The LCD display has three screens. Two of them can be accessed at

any time the key is on. The ﬁ rst screen shows the machine status and

the second screen shows the four hour meters (ﬁ gure 21).

The two screens that can be viewed by the operator can be accessed

via the display button (ﬁ gure 22) on the control panel to the left of the

key switch. Pressing this button toggles the display between the avail-

able screens.

The third screen is for diagnostics only. This screen displays any errors

that might occur or if the system diagnostics ﬁ nds something wrong.

When the diagnostic screen comes up, refer to the trouble shooting

guide for suitable action to resolve the error code.

How to Read the Solution Empty Indicator (see ﬁ gure 23, A)

The solution empty indicator is located on the front of the machine

below the LCD display. When the solution reaches nearly empty, the

indicator will begin to ﬂ ash, warning the operator of the need to reﬁ ll.

NOTE: Solution run times will vary depending on solution ﬂ ow

setting.

How to Read the Recovery Full Indicator (see ﬁ gure 23, B)

The recovery full indicator is located on the front of the machine below

the LCD display. When the recover tank is near full the indicator will

begin to ﬂ ash, warning the operator of the need to empty the recovery

tank. The vacuum motors will shut down a few moments later.

NOTE: Recovery times will vary depending on

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 129 130

Commentaires sur ces manuels

Pas de commentaire

Clarke 00311C Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Scrubber Clarke 00311C