Clarke 00311C Manuel de l'opérateur télécharger pdf (Page 14)

ENGLISH

Page -14- Form No. 71171A Clarke

Operator’s Manual (EN) - Focus Rider

How To Prepare the Machine For Operation

How To Change or Rotate Brushes on Cylindrical Brush Head

To install or rotate brushes on the cylindrical brush head:

1. Raise the brush deck and turn the key switch “OFF”.

2. Raise the brush skirt and pull out to remove. See ﬁ gure 11.

3. Remove thumb screw from brush door. See ﬁ gure 12.

4. Lower door approximately 1/2 inch and slide door and hub

assembly from brush. See ﬁ gure 13.

5. Slide brush off hub at opposite end. See ﬁ gure 14.

6. Rotate brush or replace.

7. Slide brush on drive hub and insert door and hub assembly

into brush core.

8. Raise door and install thumb screw.

9. Place side skirt on retainer pins and lower in place.

Figure 11

Figure 12

Figure 13

Figure 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 129 130

Pas de commentaire

Clarke 00311C Manuel de l'opérateur Page 14