Clarke BOOST 28 Manuel de l'opérateur télécharger pdf (Page 16)

ENGLISH

-16- FORM NO. 71483A Clarke

Operator’s Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER

Figure 14

Figure 15

HOW TO PREPARE THE MACHINE

FOR OPERATION

How To Change Or Reverse Bristle Direction

On Cylindrical Machine

To install or reverse bristle direction on the machine, follow this pro-

cedure:

1. Turn the key switch “ON”.

2. Put the brush head assembly in the “UP” position.

3. Turn the key switch “OFF”.

4. Go to the front of the machine and loosen thumb screw on

brush door. See ﬁ gure 14.

5. Lower door approximately 1/2 inch and remove brush door.

6. Remove brush. See ﬁ gure 15.

7. Inspect brush condition. If damaged or worn, replace it. Oth-

erwise, turn brush end for end periodically to reverse bristle

direction for better life.

8. Slide brush onto driver or opposite side and rotate slowly until

drive lugs are lined up with brush slots. Push brush all the

way in.

9. Install brush door assembly into brush.

10. Raise door and tighten thumb screw.

11 Repeat for the other brush.

DANGER: Operating a machine that is not com-

pletely or fully assembled could result in

injury or property damage. Do not oper-

ate this machine unless it is completely

assembled. Inspect the machine care-

fully before operation.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 123 124

Pas de commentaire

Clarke BOOST 28 Manuel de l'opérateur Page 16