Clarke Encore S33XP Manuel de l'opérateur télécharger pdf (Page 12)

Page -12- Clarke

Operator's Manual -Encore S28XP/S33XP/S38XP

How To Charge The Batteries

WARNING: Charging the batteries in an area

without adequate ventilation

could result in an explosion. To

prevent an explosion, charge the

batteries only in an area with

good ventilation.

WARNING: Lead acid batteries generate

gases which could explode.

Keep sparks and flames away

from batteries. NO SMOKING!

WARNING: Failure to disconnect the AC plug

from the wall receptacle before

connecting or disconnecting the

DC connector on the charger

could result in an explosion. Al-

ways disconnect the AC plug

from the wall receptacle before

connecting or disconnecting the

DC connector on the charger.

To charge the batteries, follow this procedure:

1. Put the charger on a flat surface. Make sure the

vents on the sides are at least two inches away

from walls and other objects. Make sure there are

no objects near the vents on the bottom of the

charger.

2. Make sure the key switch is in the “OFF” position.

3. Disconnect the battery pack connector from the

control housing connector. See figure #11.

4. Connect the DC connector on the charger to the

battery pack connector. See figure #12.

5. Connect the charger to a properly grounded single

phase (3-wire) wall receptacle having the voltage,

frequency, and ampere capacity specified on the

nameplate of the charger.

For more instruction on the use of the charger, read the

instruction book supplied with the charger.

HOW TO PREPARE THE MACHINE FOR OPERATION

Figure # 11

Figure #12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Pas de commentaire

Clarke Encore S33XP Manuel de l'opérateur Page 12