Clarke BOOST 28 Manuel de l'opérateur télécharger pdf (Page 24)

ENGLISH

Operator’s Manual - FOCUS

II L17 - S20 - L20 - L20 Cyl. - BOOST

L20

SQUEEGEE CLEANING

NOTE

The squeegee must be clean and its blades must be in

good conditions in order to get a good drying.

CAUTION!

It is advisable to wear protective gloves when

cleaning the squeegee because there may be sharp

debris.

Drive the machine on a level ﬂ oor.

Turn the ignition key (A, Fig. 25) to "0".

Lower the squeegee (B) with the lever (C).

Loosen the knobs (D) and remove the squeegee (B).

Disconnect the vacuum hose (E) from the squeegee.

Clean the steel or the aluminum squeegee (Fig. 26). Clean

the compartments (A) and the hole (B) especially. Check the

front blade (C) and the rear blade (D) for integrity, cuts and

tears; if necessary replace them (see the procedure in the

following paragraph).

Assemble the squeegee in the reverse order of disassembly.

Figure 25

Figure 26

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 141 142

Pas de commentaire

Clarke BOOST 28 Manuel de l'opérateur Page 24