Clarke 195TE Spécifications télécharger pdf (Page 18)

NOTE: These machines are designed to accept either the Clarke 5kg or 15kg wire

spools of mild steel, stainless steel or aluminium according to the type of metal you

wish to weld.Wire spools must be purchased separately. See your Clarke dealer for

full details.

B. Loading the Wire

Mig 230TE

Plug the torch hose into

the socket on the front of

the welder and secure

by hand screwing in the

threaded connection.

1. Pressure plate

2. Mounting Shaft

3. Wire Spool

4. Collar

5. Flat Washer

6. Spring

7. Plastic Nut

1. IMPORTANT: Ensure that the gas and

electrical supplies are disconnected.

2. To fit the wire spool, firstly open the side

compartment by pulling the recessed

catch backwards.

3. Turn the plastic knob with cam (7) to the

position shown in Fig. 4, i.e. with the flat

uppermost, so that the latch is unlocked,

and pull off the collar (6).

4. Slide the spool on to the shaft, ensuring that

the Peg ‘A’ locates snugly in locating hole

‘B’, ensuring the direction of feed of the wire

is in the direction of the arrow.

Replace the collar - 4, (5kg

spool ONLY), and turn the

Plastic knob with cam (7)

through 180 degrees, to the

position shown in Fig.6 thereby

locking the spool on the shaft.

Fig.4

Fig.5

Fig.3

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Pas de commentaire

Clarke 195TE Spécifications Page 18