Clarke CMS10S2 Instructions d'exploitation télécharger pdf (Page 21)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

45 DEGREE STOP ADJUSTMENT

1. Loosen the bevel clamp handle

and set the saw head as far to the

left as possible (this should be the

45° angle)

2. Place a 45° set square on the

table and up against the blade.

NOTE: Do not touch the tips of the

blade teeth with the square.

3. Turn the 45° adjustment stop screw in or out until the blade is at 45° to the

table as measured with the square.

4. Adjust the bevel point if required as shown in point 6 above.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Clarke CMS10S2 Instructions d'exploitation Page 21