Connecting to source using cigarette lighter plug:
The cigarette lighter plug is suitable for operating the inverter at power outputs up to 150
watts. The tip of the plug is positive and the side contact is negative. Connect the inverter
to the power source by inserting the cigarette lighter plug firmly into the cigarette lighter
socket of a vehicle or other DC power source.
Connect directly to power source when operating above 150 Watts.
NOTE: Most vehicle cigarette lighter circuits use fuses rated at 15 to 20 Amps or greater. To
operate at full power output, either use the battery clamp cable (supplied) or directly wire
to the power source with user-supplied wire and fuse.
CAUTION: Reverse polarity connection will result in a blown fuse and may cause permanent
damage to the inverter.
Connecting to a Power Source Using Cables Connectors Provided:
If the inverter is to be used for extended periods at power levels above 150 watts, direct
connection to the power source is necessary. Use the cables provided to connect the
inverter directly to the 12 volt power source using the following guidelines:
1. Check to be sure the inverter’s power switch is turned OFF and that no flammable
fumes are present.
2. Connect the black cable to the black post marked “(-)” on the back of the inverter.
Connect the black battery clip to the negative terminal of the battery.
3. Connect the red cable to the red post marked “(+)”on the back of the inverter.
Connect the red battery clip to the positive terminal of the battery.
4. Check to ensure that all connections between battery clips and terminals are
clean and secure.
CAUTION: Loose connectors may cause overheated wires and melted insulation. Check
to make sure you have not reversed the polarity.
4.3. Connection to Load
With the inverter connected to the power source, but switched OFF, plug the cable, from
the appliance you wish to operate, into the AC receptacle on the inverter. Switch ON and
the green LED will illuminate to indicate that the inverter is functioning. Make sure the
combined load of your equipment does not exceed the rated output of the converter
(Watts).
The Inverter is engineered to be connected directly to standard electrical and electronic
equipment in the manner described above.
WARNING:
DO NOT UNDER ANY CIRCUMSTANCES connect the Inverter to household AC circuits
CAUTION: RECHARGEABLE APPLIANCES
Certain rechargeable devices are designed to be recharged by plugging them directly
into an AC receptacle. Do not use the inverter to recharge these devices as they could
damage the inverter.
This problem does not occur with the majority of battery operated equipment. Most of
these devices use a separate charger or transformer that is plugged into an AC receptacle.
The inverter is capable of running most chargers and transformers.
-6-
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels