Clarke RS-16 DC Manuel de l'opérateur télécharger pdf (Page 3)

ENGLISH

Clarke

American Sanders Operator's Manual (EN) - RS-16 HDTR - 3 -

OPERATOR SAFETY INSTRUCTIONS

WARNING AVERTISSEMENT ADVERTENCIA

DANGER means: Severe bodily injury or death can occur to you or other personnel if the DANGER statements found on

this machine or in this Owner’s Manual are ignored or are not adhered to. Read and observe all DAN-

GER statements found in this Owner’s Manual and on your machine.

WARNING means: Injury can occur to you or to other personnel if the WARNING statements found on your machine or in

this Owner’s Manual are ignored or are not adhered to. Read and observe all WARNING statements

found in this Owner’s Manual and on your machine.

CAUTION means: Damage can occur to the machine or to other property if the CAUTION statements found on your

machine or in this Owner’s Manual are ignored or are not adhered to. Read and observe all CAUTION

statements found in this Owner’s Manual and on your machine.

DANGER: Failure to read the Owner’s Manual prior to operating or attempting any service or maintenance procedure to your machine

could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You

must have training in the operation of this machine before using it. If you or your operator(s) cannot read English,

have this manual explained fully before attempting to operate this machine.

DANGER: To reduce the risk of re, use only commercially available oor cleaners and waxes intended for machine application.

DANGER: Risk of explosion. Floor sanding can result in an explosive mixture of ne dust and air. To reduce risk of explosion, use

oor sanding machine only in well ventilated area.

DANGER: Operating a machine that is not completely or fully assembled could result in injury or property damage. Do not operate

this machine until it is completely assembled. Inspect the machine carefully before operation.

DANGER: Electrocution could occur if maintenance and repairs are performed on a unit that is not disconnected from the power

source. Disconnect the power supply before attempting any maintenance or service. Always remove the electrical plug

from the electrical outlet before changing the brush, pad or other attachment and before leaving the machine.

DANGER: Using a machine with a damaged power cord could result in an electrocution. Do not use the machine if the power cord is

damaged. Do not use the electrical cord to move the machine.

WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs

must be performed by authorized personnel only. Keep all fasteners tight. Keep adjustments according to specications.

WARNING: Electrical components of this machine can “short-out” if exposed to water or moisture. Keep the electrical components of

the machine dry. Wipe the machine down after each use. For storage, keep the machine in a dry building.

WARNING: Always use a three-wire electrical system connected to the electrical ground. For maximum protection against electric

shock, use a circuit that is protected by a ground fault interrupter. Consult your electrical contractor.

WARNING: To prevent damage to the power cord, do not let the brush, pad, pad driver or wheels touch the power cord when the

machine is running. Always lift the cord over the machine. Do not pull the power cord to move the machine.

WARNING: Operating a machine without observing all labels and instructional information could result in injury or damage. Read all

machine labels before attempting to operate. Make sure all of the labels and instructional information are attached or

fastened to the machine. Get replacement labels and decals from your authorized distributor.

1 2 3 4 5 6 7 8 ... 31 32

Pas de commentaire

Clarke RS-16 DC Manuel de l'opérateur Page 3